Page Comparison

Gumband Hardware, is a custom embedded system design for new Exhibit development on Gumband, it is a wired ethernet platform built around an Infineon PSoC chip with dual core ARM processor. It has the Gumband stack built-in to seamlessly monitor and interact with physical hardware such as buttons, sensors, LEDs, and motors. This platform also allow allows for remote firmware updates across a fleet of hardware.

• ARM M0+ core handles the entire Gumband communication stack

• ARM M4 core is entirely available for user firmware

• Program using the Arduino IDE with the Gumband board library

• Program natively through Infineon PSoC Creator (advanced)

• Two 2x13 connectors (100mil pitch)

• 40 multipurpose GPIO pins

• Existing API supports I2C, UART, SPI, Ethernet, PWM, ADC

• Additional protocols (RS485, CAN, LIN, ModBus, etc.) supported by MCU