Versions Compared

Old Version 2

changes.mady.by.user Thomas Driscoll

Saved on

compared with

New Version 3

changes.mady.by.user Thomas Driscoll

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Excerpt
nameDevelopment Board Image
Image of the Gumband development board revision 02bImage RemovedImage of the Gumband development board revision 02bImage Added
Excerpt
nameDevelopment Board InfoDescription

Gumband Hardware, is a custom embedded system design for new Exhibit development on Gumband, it is a wired ethernet platform built around an Infineon PSoC chip with dual core ARM processor. It has the Gumband stack built-in to seamlessly monitor and interact with physical hardware such as buttons, sensors, LEDs, and motors. This platform also allow for remote firmware updates across a fleet of hardware.

  • ARM M0+ core handles the entire Gumband communication stack

  • ARM M4 core is entirely available for user firmware

  • Program using the Arduino IDE with the Gumband board library

  • Program natively through Infineon PSoC Creator (advanced)

  • Two 2x13 connectors (100mil pitch)

  • 40 multipurpose GPIO pins

  • Existing API supports I2C, UART, SPI, Ethernet, PWM, ADC

  • Additional protocols (RS485, CAN, LIN, ModBus, etc.) supported by MCU

...

Excerpt
nameDevelopment Module InfoDescription

The native Gumband Hardware is also available as a module in a smaller SMT form factor without losing any functionality from the larger board. Requiring only an external Ethernet connector it is designed to be incorporated directly into a custom circuit board designed for your end application. At 35mm square it is small enough to be incorporated directly into almost any custom system.