Versions Compared

Old Version 2

changes.mady.by.user Thomas Driscoll

Saved on

compared with

New Version Current

changes.mady.by.user Thomas Driscoll

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Status
colourPurple
titleRev. 02b02C

Excerpt
nameDevelopment Board Image
Image of the Gumband development board revision 02bImage RemovedImage of the Gumband development board revision 02bImage Added
Excerpt
nameDevelopment Board InfoDescription

Gumband Hardware, is a custom embedded system design for new Exhibit development on Gumband, it is a wired ethernet platform built around an Infineon PSoC chip with dual core ARM processor. It has the Gumband stack built-in to seamlessly monitor and interact with physical hardware such as buttons, sensors, LEDs, and motors. This platform also allow allows for remote firmware updates across a fleet of hardware.

  • ARM M0+ core handles the entire Gumband communication stack

  • ARM M4 core is entirely available for user firmware

  • Program using the Arduino IDE with the Gumband board library

  • Program natively through Infineon PSoC Creator (advanced)

  • Two 2x13 connectors (100mil pitch)

  • 40 multipurpose GPIO pins

  • Existing API supports I2C, UART, SPI, Ethernet, PWM, ADC

  • Additional protocols (RS485, CAN, LIN, ModBus, etc.) supported by MCU

Pinout diagram of the Gumband development board revision 02bImage Removed
Excerpt
nameDevelopment Board Pinout
Image Added

Arduino IDE Development

...

PSoC Native IDE Development

The Gumband Development Board is built around a dual-core PSoC 6 MCU and a much greater range of capabilities can be achieved by developing in PSoC Creator or Modus Toolbox (the native PSoC IDEs). However it should be noted that any application developed under these IDEs that use the schematic editor or custom hardware blocks will not be compatible with an application developed using the Arduino IDE, this includes the core Gumband image.

Gumband Module

Status
colourPurple
titleREV. 01

Excerpt
nameDevelopment Module Image

Excerpt
nameDevelopment Module InfoDescription

The native Gumband Hardware is also available as a module in a smaller SMT form factor without losing any functionality from the larger board. Requiring only an external Ethernet connector it is designed to be incorporated directly into a custom circuit board designed for your end application. At 35mm square it is small enough to be incorporated directly into almost any custom system.