Gumband Hardware, is a custom embedded system design for new Exhibit development on Gumband, it is a wired ethernet platform built around an Infineon PSoC chip with dual core ARM processor. It has the Gumband stack built-in to seamlessly monitor and interact with physical hardware such as buttons, sensors, LEDs, and motors. This platform also allow allows for remote firmware updates across a fleet of hardware. ARM M0+ core handles the entire Gumband communication stack ARM M4 core is entirely available for user firmware Program using the Arduino IDE with the Gumband board library Program natively through Infineon PSoC Creator (advanced) Two 2x13 connectors (100mil pitch) 40 multipurpose GPIO pins Existing API supports I2C, UART, SPI, Ethernet, PWM, ADC Additional protocols (RS485, CAN, LIN, ModBus, etc.) supported by MCU
| 
